Waterproof Archives - Page 4 of 8

Showing 37–48 of 85 results

IP69K Screw Lock Cable for RJ45 and M12 Gigabit Vision Links

An IP69K screw lock cable for camera and PLC links on lines that get hosed down with hot water and detergent every shift. Screw-lock RJ45 or M12 8-pin couplings, PUR or stainless braid jacket, sealed at the mated pair, which is the only condition that matters on the line.

M12 3-Pin A-Coded Sensor / Actuator Extension Cable

This M12 actuator cable is the three-conductor A-coded extension used to replace or lengthen the last segment of a sensor drop without pulling new cable back to the cabinet. IEC 61076-2-101, IP67 mated, 60 V / 4 A, 24 AWG, PVC or PUR jacket, built to your pinout and length.

m12-4-pin-female-inner-mold-pe-cross-section

M12 4-Pin A-Coded Right-Angle Shielded Sensor Cable

This M12 4 pin shielded cable carries analog and sensor signals past variable frequency drives without the noise that ruins an unshielded drop. Foil plus braid screen, right-angle A-coded female body, 24 AWG conductors, bonded to the coupling nut per your drawing.

m12-8-pin-ip67-waterproof-extension-cable

M12 8-Pin A-Coded IP67 Waterproof Male-Female Extension Cable

This M12 8 pin cable carries two complete circuits or full encoder feedback in one IP67 A-coded shell, saving a second run and a second part number. 30 V / 2 A per pin, 8 x 24 AWG, PUR jacket for oil and UV, built to your pinout and length.

m12-8-pin-right-angle-straight-extension-cable

M12 8-Pin A-Coded Right-Angle / Straight Extension Cable

An m12 8 pin extension cable with a right-angle male end and a straight female end, both overmolded, IP67 and A-coded to IEC 61076-2-101. 8 x 24 AWG in TPU or PVC for I/O blocks and tight cabinet runs.

m12-a-code-4-pin-y-splitter-sensor-cable

M12 A-Code 4-Pin Y-Splitter Sensor / Actuator Cable

This M12 y splitter sensor cable turns one four-position A-coded port into two, so one home run feeds two sensors or actuators. IEC 61076-2-101, IP67 molded Y block, 4 A / 60 V DC, PVC or PUR. Size the trunk for both loads.

M12 A-Code Push-Pull Sensor Cable, IP67

This m12 push pull cable keeps the A-coded sensor pinout the industry knows and swaps the screw thread for a push-pull coupling: press the shells together and the retaining latch locks, so a connection that took several turns now takes a second.

m12-a-coded-pvc-pur-straight-right-angle-extension-cable

M12 A-Coded PVC/PUR Straight or Right-Angle Extension Cable

This M12 PVC PUR cable is offered in straight or right-angle A-coded bodies with 3 to 8 positions, so the two decisions are jacket compound and exit direction. PVC for dry enclosures, PUR for oil, coolant, UV and flexing runs. Built to length.

M12 Bulkhead Panel Connector with Pigtail, A, D and X Coding

An M12 bulkhead panel connector takes sensor, fieldbus and industrial Ethernet wiring through an enclosure wall in one threaded penetration. A, B, D or X coding, front or rear mounting, solder terminals or a molded pigtail on the back. Cut-out confirmed per drawing.