Kenwood Radio Power Cable PG-2N PG-3N PG-4N

Replacement 12 V DC power cable for Kenwood mobile and amateur radios. PG-2N fits TM-261/461/271/471, PG-3N fits TK-768G/868G/7108/8108, PG-4N fits TK-768/868/708/808. Pre-wired lead with in-line fuse holder.

Overview

Every assembly is built to the pinout, length and jacket specification agreed on the order, so the lead that arrives is the one the job actually needs rather than a generic part that mostly fits.

Key Specifications

Cable Type: Radio Power Cable
Voltage: 12 V DC
Variant: PG-2N, PG-3N, PG-4N
Application: Kenwood Mobile / Amateur Radio

Construction and Materials

Pre-wired DC lead with red and black conductors and an in-line blade fuse holder on the positive run. The fuse holder sits close to the battery end, which is where it belongs: the job of that fuse is to protect the cable run, not the radio.

Typical Applications

Replacement or spare DC lead for Kenwood mobile and amateur radio installations where the original cable has been cut short, damaged or lost. Also used to pre-wire a vehicle so the same radio can be moved between cars without re-terminating each time.

Compatibility and Fitment

PG-2N suits the TM-261, TM-461, TM-271 and TM-471 series. PG-3N suits the TK-768G, TK-868G, TK-7108 and TK-8108 series. PG-4N suits the TK-768, TK-868, TK-708 and TK-808 series. Check the connector shape against the radio rear panel, because the three variants look similar but are keyed differently.

Custom Builds and Ordering

Cable length, conductor cross section, jacket material and connector plating can all be specified per order. Send the pinout or a sample and the assembly will be built to match, with OEM and bulk packaging available for production runs.